Bell-gossett S12260 R4 Genuine Bell & Gossett Replacement S Bedienungsanleitung PDF herunterladen

INSTRUCTION MANUAL

S12260

REVISION 4

GENUINE BELL & GOSSETT

REPLACEMENT SEAL KIT

INSTRUCTIONS FOR ALL PUMPS

EQUIPPED WITH MECHANICAL SEAL

1. Remove impeller, old seal assembly, insert, and insert cup.

2. Clean shaft, shaft sleeve and insert recess. Apply soap & water

lubricant when installing new insert cup and insert.

3. When pump and motor shafts are separate, push pump shaft

forward from rear of bearing assembly to take up end play.

Maintain this position while pressing seal ﬁrmly in place.

4. Moisten inner diameter of seal ring assembly and press down

tightly on pump shaft. Carbon seal face must be tight against

insert.

5. Replace impeller and reassemble in line. Be sure to vent air

from pump body thoroughly before operating.

186543 (Kit No. 8)

Used on 1531, 1510 and Universal pumps of all bronze and

bronze-ﬁtted construction with 1-5/8” shaft sleeve diameter.

186544 (Kit No. 9)

Used on 1531 and 1510 pumps of all iron construction with 1-5/8”

shaft sleeve diameter.

185225 (Kit No.16) EPR w/ TC insert

Used on 1531 and 1510 pumps with 1-5/8” shaft sleeve diameter.

Xylem Inc.

8200 N. Austin Avenue

Morton Grove, Illinois 60053

Phone: (847) 966-3700

Fax: (847) 965-8379

www.xyleminc.com/brands/bellgossett

Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.

INSTRUCTION MANUAL S12260 REVISION 4GENUINE BELL & GOSSETTREPLACEMENT SEAL KITINSTRUCTIONS FOR ALL PUMPSEQUIPPED WITH MECHANICAL SEAL 1. Remove im

Keine Kommentare

Bell-gossett S12260 R4 Genuine Bell & Gossett Replacement S Bedienungsanleitung